Jump to content

How to utilise the Hi and Lo on hold buttons?


Fruity Nut
 Share

Recommended Posts

Gary will probably know this one...

So on a game such as Viva Espana which has separate Hi and Lo buttons. I have edited the layout to use the Hi and Lo on my cabinets Hold buttons which works fine but how do I get them to flash when the Hi and Lo should flash in game but still flash when the holds should flash, essentially sharing the same buttons? 

Is this possible? 

IMG_20240220_190353.jpg

IMG_20240220_190600.jpg

IMG_20240220_190607.jpg

Link to comment
Share on other sites

Not sure if this is how but at a guess I’d say add the lamp numbers from the single hi lo buttons to the buttons you want use. each button can be allocated two lamps in pacdrive settings lamp 1 and lamp 2, so if hold is say lamp 36 and the hi button is 48 insert lamp 36 as lamp 1 and 48 as lamp 2. Not on laptop at moment so can’t double check if this is how it’s done. 

Link to comment
Share on other sites

7 minutes ago, Ginge said:

Not sure if this is how but at a guess I’d say add the lamp numbers from the single hi lo buttons to the buttons you want use. each button can be allocated two lamps in pacdrive settings lamp 1 and lamp 2, so if hold is say lamp 36 and the hi button is 48 insert lamp 36 as lamp 1 and 48 as lamp 2. Not on laptop at moment so can’t double check if this is how it’s done. 

I think I tried that but not too sure how to do it correctly in edit, design. I managed to get them to work but it stopped them flashing when hold should normally flash. 

Edited by Fruity Nut
Link to comment
Share on other sites

 Share

×
×
  • Create New...