Jump to content

Tips: Enhanced DX Graphics


Reg
 Share

Recommended Posts

Looking through the history of MFME, some layouts will show that the lamps have simply been brightened on layouts.

One example is below...

241116_SpiceUp_0001.png

You can clearly see thee off colour of the layout and these lamps have just had there brightness and contrast altered to fix.

Let's take a look at this board again after some work has gone into this...

241116_SpiceUp_0002.png

This looks better now and more effort has gone into this - but it only took an extra two minutes to do.

This was achived in two minutes by doing the following to each lamp where you wanted the effect.

241116_SpiceUp_0003.png

Go into Properties of the lamp, right click on the empty mask field and select Default and then finally Apply.

  • Like 2
Link to comment
Share on other sites

  • 3 weeks later...
 Share

×
×
  • Create New...