Leaderboard

Well I'm onto version 10 of this print trying to figure out the right size to fit everything in and I think I'm finally nearly there! There's alot to cram inside in such a small space, as seen below: I reckon I need to add another 1cm to the width and it will be just enough. It works now but I feel like I am forcing the wires in against their will! I decided to make a modular system for mounting the Pacdrive and controller board. This way you can choose what board you have, print it out, screw it onto the mount and just slide it in place: Anyway, it is nearly ready to share once I resize it one last time to make it wider and here is a POC showing it working with MFME: I printed this on my Bambu Labs A1 and it prints fine without any supports however it does nag me to add supports during the preparing stage (I just ignore it). If anyone would like to test it out with their printer please let me know. All the best, Steve

Is BPAK a known format? That is to say, it's already been reverse engineered?

That looks really good. What front end are you using?